Rinnai RDT-90-RM-S, Руководство по эксплуатации, Страница: 33 / 52

32
Each press switches the time
• The timer operation time can be set within the range 5 to 90 minutes. (5 to 30 minutes can be set in 5-minute increments, and 30 to 90 minutes can be set
in 10-minute increments.)
• To cancel timer operation, press . Timer operation cannot be stopped even by pressing .
Information
2
Press and , and set the timer time.
Short beep Short beep
Short beep
Lights (green)
Blinks (green)
3
Press .
After about 5 to 10 seconds
Lights (green) Goes out
Short beep
Lights (red)
• If the or switch is pressed during operation,
the drum stops. If the equipment is left in this state for
approximately two minutes, drying operation is stopped,
and cool operation is started.
Information
4
When the buzzer sounds, remove the clothes.
When drying operation ends, the buzzer sounds (three continuous beeps). Before
opening the front door, make sure that the operation/combustion lamp is off and
the SOFTEN&COOL lamp is blinking or on (green).
• Wait for the drum to come to a complete stop before removing clothes.
• Note that the lint filter and the area around the clothes removal port is hot immediately after operation ends.
Caution
• Cool operation begins after one minute if clothes are not taken out. Also, to lower the temperature inside the drum after removing clothes, close the front
door and resume cool operation after approximately two minutes. Operation automatically stops when cool operation ends.
• If drying operation is continued immediately after cooling operation, drying operation begins immediately after cooling operation of two minutes maximum.
• For details on how to stop cool operation, see pages 29.
Information
(3 beeps)