8. Don’t clean the top of the sensor with a hard brush, as
it may damage the sensor. (Fig 7)
9. Turn the ignition control the knob backwards to the
“OFF” position to extinguish the burner.
HOW TO HANDLE SAFETY DEVICE AND CHANGE BATTERY
1. If the flame is extinguished during operation, the automatic flame failure
safety device will shut the gas off after a short delay.
If you notice that the flame has been extinguished, please turn the knob to
“OFF” position.
- 5 -
- 2 -
10. Turn off valve of gas cylinder after cooking .(Fig 6)
Fig.6
11. Not very anxious signals:
- Difficult ignition: At the first use, there is full air in the gas hose. So, it
is difficult to ignite. Please make ignitions a few times, the ignition is
successful.
- The sound “pop” when gas cooker is switched off, is very normal sound;
please do not pay much attention.
SPECIFICATIONS
Power supply
Gas Input
Gas Inlet connection
1.5VD.C ( “C” size battery)
Pressure
LPG 300mmH2O 3.0 kpa 11.8 IN.W.G.
NG 250mmH2O 2.5 kpa 9.8 IN.W.G.
TG 80mmH2O 0.8 kpa 3.1 IN.W.G.
INSTALLATION
* This built-in gas cooker is to be used for cooking only. Do not dry towels,
clothes, etc, over it.
* Install the built-in gas cooker in a well ventilated room and keep it away
from any combustible or flammable objects such as paper or oil.
BENCHTOP CUT-OUT DIMENSIONS:
Fig.2
LP 9,5
TG 1/2 In thread (male)
Net weight
Overall dimensions
Height
Length
Width 420 mm
750 mm
150 mm (Include pan support)
2. The safety sensor is delicate, it should always be kept
clean and dry system and please do not use
stiff brushes or rough cleaning pads for
cleaning.(Fig 7).
Fig.7
Flame sensor
Hard brush
All (LPG) 9.0 kW (657g/h)
Right 3.7 kW Left 3.7 kW Middle 1.6 kW
All (NG) 7.8 kW
Right 3.2 kW Left 3.2 kW Middle 1.4 kW
All (TG) 7.8 kW
Right 3.2 kW Left 3.2 kW Middle 1.4 kW
Cut out size
642mm
~ 680mm x 342mm ~ 360mm x R0 ~ R50
12.4 kg (Enamel pan suport
)
13.5 kg (Cast Iron pan suport
)
* Set battery correctly with care.
3. Aeration is preset at Factory, Please do
not attempt to adjust it.
* Battery Box is located at bottom of casing
(Size C, 1.5V DC) (Fig.8)
Open the door of cabinet, and change battery
Fig.8
Diameters of pan which may be used on the hobs
Burners
Min
Max
Wok Burner
280mm
120mm
* Use only flat bottom pan except for wok burner
Semi-rapid
160mm
90mm
