12
Fixing the appliance
Ensure that the hob is installed on a flat and supporting
surface. Any deformities to the appliance caused during
improper installation could affect the hob operation.
Fix the 2(two) L-shaped brackets using 4(four) screws
supplied. Observe the bracket installation distance as
shown in installation cut-out drawings.
Stick the sealing strip (provided) on the underside of
the hob around the outside edge (see inlet). Be
careful not to stretch the sealing strip.
Place the hob centrally in the installation cavity and
secure the hob firmly to the bracket using 4(four)
screws provided. Ensure that the sealing strip
secured on underside of hob edges is in place.
Make the electrical connection and connect to power
supply.
Check that the hob operates normally.
Connecting the supply cable to the power mains
An adequate electrical supply must be provided for
this unit. Check voltage on rating label.
The installer must ensure that the correct electrical
connection has been made and that it is compliant
with local safety regulations.
If the appliance is being directly connected to the
power mains supply, an omnipolar circuit breaker
must be installed with a minimum gap of 3mm
between the contacts, suitable for the load indicated
and complying with current electrical regulations (the
earthing wire must not be interrupted by the circuit
breaker). The supply cable must not come into
contact with surfaces with temperatures higher than
50
0
C.
Before connecting to power supply, ensure that:
The appliance is correctly and efficiently earthed.
Use an electrical connector with earth that is
correct for your location. The electrical connection
of this appliance must be connected to earth
(where
applicable): Green & Yellow = EARTH; Blue =
NEUTRAL; Brown =LIVE
The socket can withstand the maximum power of
the appliance, and voltage within the value range
indicated on the rating label attached to the
appliance.
The basic safety requirement should be tested by a
qualified technician. Multiple plugs and extension
cables must not be used. Overloading is dangerous
and may cause a fire hazard.
Once the appliance has been installed, the power
supply and electrical socket must be easily
accessible.
Never glue or silicone the appliance unit to the
installation cavity. The appliance must be easily
removed out of the cavity for servicing or repair.
Electrical connection must be performed by a qualified
electrician.
The installer must ensure that the correct electrical
connection has been made and that it is compliant with
local safety regulations.
The manufacturer cannot be held responsible for any
unit malfunction due to an inadequate electrical supply
nor any liability should these safety measures not be
observed.
En
gl
ish
