Rinnai infinity 26 touch REU-VRM2626WD, Руководство по эксплуатации и установке

Страница: 37 / 44

Rinnai Australia 37 Installation Manual
WIRELESS WATER CONTROLLER INSTALLATION
MOUNTING THE WIRELESS WATER CONTROLLER
• Metallic structures, appliances or magnetic fields in the vicinity of transceiver or
wireless water controllers may reduce signal strength.
• Do not install wireless water controllers near a heat source, such as a cook top, stove
or oven. Heat, steam, smoke and hot oil may cause damage.
• Do not install wireless water controllers in direct sunlight.
• Do not install wireless water controllers outdoors unless protection from dust
ingress and sunlight are provided.
• Wireless water controllers MUST NOT be installed where chemicals such as benzene,
alcohol, turpentine, hydrogen sulphide, ammonia, chlorine or other similar chemicals
are in use.
1. Determine the most suitable position for the water controller (see “POSITIONING OF
TRANSCEIVER AND WIRELESS WATER CONTROLLERS” on page 31).
The ‘Signal Strength’ indicator displays one of four levels.
The ‘Out Of Range’ indicator displays when the wireless water controller is out of range of
the transceiver or when an object is obstructing the radio signal.
Wireless water controllers should be positioned such that the signal strength indicator displays
at least ‘2 bars’ next to the antenna symbol
during installation. Signal strength varies with
atmospheric and other conditions. If the signal strength is weaker than ‘2 bars’ during installation,
there may be other times when the signal is too weak to allow operation.
2. Slide the wireless water controller from its’ wall mounting bracket.
3. Use the wall mounting bracket as a template to mark off and drill 2 holes for use with mounting
fixings.
4. Secure the wall mounting bracket to the wall with the screws and or anchors provided. Avoid
over-tightening of fixings as this may cause damage. DO NOT use powered tools to tighten
fixings.
5. Slide the wireless water controller back into its’ wall mounting bracket.
ADDITIONAL WATER CONTROLLER MOUNTING CONSIDERATIONS.
The MC-503RC uses a Liquid Crystal Display (LCD) for the digital
monitor. Light reflections can make the LCD difficult to see at direct
eye level.
For best results when Installing the MC-503RC mount the remote
controller lower than your eye-level to avoid these light reflections.
NOTE
Strong Weak
142
66.6
31.5
13.8
81.7
28
NOTE