12
A scroll saw is fundamentally a “curve cutting tool” but
which can also carry out straight and angled edge cuts.
Familiarize yourself with the following important points prior
to commissioning the saw.
• The saw does not automatically cut wood. You must feed
the wood against the saw blade manually.
• The cutting process occurs while the blade is moving.
• Feed the wood slowly against the saw blade as the saw
blade teeth are small.
• Persons carrying out work with the saw require training.
The saw blade may break easily during this training time
while the operator is still unfamiliar with the saw.
• The saw is best suited for sheets of wood less than 25
mm (1’’) thick.
• Feed the wood especially slowly against the blade
and avoid abrupt curves to prevent the saw blade from
breaking, if you wish to cut wood sheets thicker than 25
mm (1’’).
• Saw blade teeth will get dull over time, saw blades must
be replaced. Blade wear depends on type of wood and
operator.
• Try and make sure that the saw blade follows the grain
of the wood in order to obtain a clean cut.
• The saw speed must be reduced to minimum when cutting
precious and non-ferrous metals.
Inside cuts
Warning: Switch off the saw and remove the cord from
power supply before installing saw blades in order to
avoid injuries caused by unintentional activation of the
saw. This saw is suited also to inside cuts, or cuts not
starting at the edge of the work piece.
Proceed as follows:
• Drill a 6mm (1/4’’) hole in the work piece.
• Turn the blade tension knob to release the tension in
the blade.
• Place the bore hole over the saw blade slot in the work
table.
• Install the saw blade through the hole in the work piece
and through the work blade slot, and fasten the blade to
the holders.
• When you have completed the inside cut, remove the saw
blade and then remove the work piece from the table.
Attaching Flexible shaft
• Remove protective cap from the threaded bushing.
• Place fl exible shaft onto the threaded bushing.
• Clamp tool in the drill chuck 3.2mm (1/8’’) diameter.
• Firmly hold threaded shaft at the handle and switch on
the speed control.
• Having finished the work, remove the fl exible shaft and
place the protective cap in place.
Attention: When working with the flexible shaft,
cover the saw blade with the blade guard.
General Usage and Maintenance
Fig. 09
Fig. 10
Fig. 11
Содержание 10-600VS
Страница 13: ...15 Parts List ...
Страница 14: ...16 Parts Explosion ...
Страница 15: ...17 Notes ...