Rikon Power Tools 10-345, Руководство пользователя

Страница: 8 / 24

Figure 1
Figure 4
8
A
B
Figure 2
Figure 3
The 10-345 Bandsaw is supplied partly assembled.
Prior to use, the following items have to be assembled:
working table, rip fence and hand-wheels.
WARNING!
To ensure sufficient upright stability and
safety of this Bandsaw, you need to bolt the Bandsaw to
the floor with M10 screws.(Fig 1) (not supplied)
Assemble Working Table
Installing 90° table stop: Thread screw (M8x25) and nut
(M8-1.25) to the bottom of the table. (Shown Fig. 5A)
With the help of another person, lift the working table
onto the trunnion.
Mount the working table to the trunnion using the
supplied (4) hex bolts, (4) lock washers and (4) washers
(A--Fig.2).
Installing Table Leveling Screw: Insert the hex socket
screw and washer through top of table. Place bushing
and wing nut from under the table and tighten. (B--Fig.
2)
Rip Fence Assembly
Install the rear fence rail to the table with (2) M6-1.0 x
20 hex bolts and (2) flat washers M6 (Fig. 3).
Install the front fence rail to the table with (4)
thumbscrews and (4) flat washers M8 (Fig. 3).
Make sure the end cap is locked into the rear fence rail.
Then set the fence on the front and rear rails.
Assemble Hand-Wheels
Attach the large crank handle (Fig. 4) to the rack and
pinion shaft on the upper part of the bandsaw, using the
5mm “L” wrench provided.
Attach the small crank handle (Fig. 4) to the belt
and speed control rod on the lower right side of the
bandsaw, using the 5mm “L” wrench provided.
Assembly