Rikon Power Tools 10-345, Руководство пользователя

Страница: 9 / 24

Figure 5
Figure 6
Figure 7
Figure 8
9
Setting the Table Square to Saw Blade
The table may be set at 90° to the saw blade sides by
adjusting the table stop screw under the table. The table
stop screw rests on the top of the quick release adjustment
stop. By first loosening the locking nut (A--Fig. 5) and
then adjusting the screw (B--Fig. 5), the table can be set
correctly. Retighten the locking nut (A--Fig. 5) making sure
that the setting is maintained.
The table may also be set at 90° to the back of the saw
blade by adjusting the trunnion micro adjustment screws.
First, slightly loosen part #98 (refer to parts explosion
on page 18 of this manual). Using the 3mm “L” wrench,
turn the rear trunnion micro adjusting screws part #125.
Turning the screws clockwise will raise the trunnion;
counterclockwise will lower. Check table for 90° and tighten
part #98.
Tilting the Table
Loosen the lock handle (A--Fig. 6) on the table trunnion.
Turn the table tilting knob (B--Fig. 6) to adjust the table
to the desired angle. Use the angle indicator scale on the
trunnion bracket to find the desired angle. Retighten the
lock handle to secure the table.
Tracking the Saw Blade
WARNING!
Unplug the Bandsaw. First, make sure the
upper and lower blade guides are adjusted away from the
blade and the tension scale is set to correspond to the
width of the blade you are using.
Then loosen the lock lever (A--Fig. 7) by turning it counter
clockwise and turn the blade tracking knob (B--Fig. 7)
clockwise/counterclockwise while turning the upper wheel
by hand at least three rotations until the blade tracks
centered on the wheel. Finally, tighten the lock lever and
close the doors.
Adjusting the Blade Tension
To loosen the tension of the blade, turn the blade tension
handwheel (Fig. 8) counter clockwise. To tighten the
tension of the blade, turn the blade tension handwheel
clockwise.
Tension the blade until the tension readings correspond
A
B
A
B
A
B
Adjustments
Caution!