Rikon Power Tools 10-050, Руководство пользователя

Страница: 13 / 27

13
Blade Guard and Splitter Installation
1. Remove table insert and raise the saw blade,
then loosen the hex head cap screw (A, Fig.17)
located on the rear table trunnion assembly. Figure
17.
2. Install guard post through slot at rear of saw
and into the hole in the trunnion. Fasten into place
with one 8MM square nut (B, Fig.17) with 14MM
wrench. Figure 18.
3. The spillter support bracket must be installed on
to guard post as shown. Figure 19.
4. Slide the guard into place and tighten the hex
head cap screw on the rear trunnion assembly
and tighten the nut on the splitter support bracket.
Figure 20.
Figure 17
Figure 18
Figure 20
Assembly
A
B
Figure 19