Riken Keiki RX-8000, Руководство по эксплуатации

Страница: 7 / 51

2 Important Notices on Safety 2-2. Warning cases
RX-8000
- 6 -
WARNING
< Sampling point pressure >

The gas detector is designed to draw gases around it under the atmospheric pressure. If
excessive pressure is applied to the gas inlet and outlet (GAS IN, GAS OUT) of the gas detector,
detected gases may leak out from its inside and may cause dangerous conditions. Be sure that
excessive pressure is not applied to the detector while used.

Do not connect the gas sampling hose directly to a location with a pressure higher than the
atmospheric pressure. The internal piping system may be damaged.
< Handling of sensor >
Do not disassemble the galvanic cell type sensor because it contains electrolyte. Electrolyte may
cause severe skin burns if it contacts skin, while it may cause blindness if its contacts eyes.
If electrolyte is adhered on your clothes, that part on your clothes is discolored or its material is
decomposed. If contact occurs, rinse the area immediately with a large quantity of water.
< Fresh air adjustment in atmosphere >
When the air calibration is performed in the atmosphere, check the atmosphere for freshness
before beginning the air calibration. If other gases exist, the adjustment cannot be performed
properly, thus leading to dangers when the gas leaks.
< Battery level check >

Before use, check that there remains sufficient battery power. When the gas detector is used for
the first time or is not used for a long period, the batteries may be exhausted. Either fully charge
the batteries or replace them with new ones before use.

If a low battery voltage alarm is triggered, gas detection cannot be conducted. If the alarm is
triggered during use, turn off the power and promptly charge the batteries in a non-hazardous
area.
< Others >

Do not throw the gas detector into fire.

Do not wash the gas detector in a washing machine or ultrasonic cleaner.

Do not block the buzzer sound hole. No alarm sound can be heard.

Do not remove the battery unit while the power is ON.

Do not drop or give shock to the gas detector by, for example, relocating the gas detector with a
water trap, an optional accessory, attached. The gas inlet may be damaged.
2-2. Warning cases