RIKA VITRA, Инструкция по эксплуатации

Страница: 9 / 20

9
E
N
G
L
IS
H
1.2 Flue pipe connection
Flue pipes are a particular hazard source in respect of
escape of poisonous gas and fire hazard. Obtain the ad-
vice of an appointed specialist company in respect of
laying and fitting the pipes. When connecting the flue pipe
to the chimney, in the area of walls cladded using wood,
please follow the relevant fitting directives.
1.3
You must follow the flue gas formation in the event of
unfavourable weather (atmospheric inversion) and the
draught conditions. If too little combustion air is added
smoke can enter your house or flue gases can escape.
Additionally harmful deposits can arise in the fire and in the
chimney. In the event that flue gas escapes let the fire go
out and check if all air inlet openings are free and the flue
gas feeds and the fire pipe are clean. In cases of doubt
you must inform the master chimney sweep, as a fault in
the draught could be due to the chimney.
1.4
Before adding new fuel, push the embers together.
1.5
Only use a suitable tool from our accessory range for
pushing the embers together, and ensure that no combus-
tible material falls out of the fire.
1.6
Use the devices supplied with your fire, uch as the protec-
tive gloves or the cold hand to open the doors, as well as
for operating the control elements.
1.7
Design 1 fires (BA 1):
These fires must only be operated with the fire door
closed.
1.8
The fire door must only be opened for adding fuel and
must then be closed again, as this could otherwise lead to
a danger to other fires that are also connected to the
chimney.
1.8.1
When the fire is not in operation, the fire door must be kept
closed.
1.9
When using wet fuel and if operation is throttled too much,
the chimney can soot up, i.e. easily combustible materials
such as soot and tar can be deposited and this can lead to
a chimney fire.
Should this happen, call the fire brigade and get your self
and all other occupants to safety.
ATTENTION: The size of the fire door means that,
particularly when reheating blazing flames, the door
must not be opened abruptly, in order to prevent the
flames from springing out.
Important information relating to ROOM AIR DEPEND-
ENT and ROOM AIR INDEPENDENT OPERATION:
Your stove has been tested as a room air dependent
stove in accordance with EN 13240 and does not fulfil
the German requirements for room air indepen ent
operation.
In combination with room air technical installations
(e.g. controlled ventilation and extraction systems,
dust extraction systems, etc) it must be ensured that
the stove and the room air technical installations are
monitored and made safe (e.g. via a differential pres-
sure controller, etc.). The required combustion air flow
of approx. 40 m3/h must be assured.
Please observe any local directives and rules in con-
sultation with the responsible chimney sweep.