RIKA Topo II, Руководство по эксплуатации

Страница: 7 / 32

|
7
EN
6
Dimensions
F-S B R-S
R-H
F-H
H
T
R-
F-
Dimensions Topo Topo XL
height [mm] 1082 1082
width [mm] 720 720
corpus depth [mm] 418 595
Weight Topo Topo XL
weight without shell [kg] 166 168
weight with shell [kg] 230 232
Flue pipe connection Topo Topo XL
R - Ø flue pipe outlet [mm] 100 100
RO - H original angle pipe connection
height
[cm] - -
RO - T1 original angle pipe total depth [cm] - -
RO - T2 original angle pipe distance
to rear wall
[cm] - -
RO - S original angle pipe side
distance
[cm] - -
R - H rear connection height [cm] 17 17
R - S rear connection side distance [cm] 10 10
Fresh air connection Topo Topo XL
F - Ø diameter [mm] 50 50
F - H connection height [cm] 14 14
F - S side distance [cm] 22 22
Convection air connection Topo Topo XL
K - Ø diameter [mm] - -
K - H connection height [cm] - -
K - S side distance [cm] - -
Amount of fuel
Burn time at full
pellet hopper
Topo (47kg) TopoXL (70kg)
nominal load ca. 24h* ca. 35h*
part load ca. 47h* ca. 70h*
*Practical values may vary depending on pellet quality.
Technical data Topo Topo XL
heating power range [kW] 3 - 10 3 - 10
room heating capacity
(depending on house insulation)
[m³] 70 - 260 70 - 260
fuel consumption [kg/h] bis 2,4 bis 2,4
pellet container capacity [kg] 47 70
electric supply [V]/[Hz] 230/50 230/50
average electrical input [W] ~ 20 ~ 20
fuse [A] 2,5 AT 2,5 AT
Efficiency [%] 91 91
CO2 [%] 11,6 11,6
CO-emission on 13% OO [mg/m
N
3
] 32 32
dust emission [mg/m
N
3
] 13 13
exhaust [g/s] 6,1 6,1
exhaust temperature [°C] 156 156
chimney draft requirement [Pa] 0 0
Note
Pellet consumption depends on the size of the pellets. The larger the pellet,
the slower the feed and vice versa
The owner of small firing systems or the person authorised for the small
firing system is to keep the technical documentation and is to submit it to the
authorities or the chimney sweep on request.
Note
Please observe the national and European standards as well as local
regulations concerning the installation and operation of firing installations!
Packaging
Your first impression is important to us!!
The packaging of your new stove provides excellent protection against damage.
However damage to the stove and accessories may still occur during transport.
Note
Therefore please check your stove on receipt for damage and completeness!
Report any deficiencies to your dealer immediately! Pay particular attention
during unpacking that the stone panels remain intact. Scratches to the
material can easily occur. Stone panels are excluded from the warranty
The packaging of your new stove is environmentally neutral to a great extent
Tip
The wood used in the packaging has not been surface treated and may
therefore be burnt in your stove. The cardboard and film (PE) can be disposed
of via the municipal waste collection for recycling.
Electrical connection
The stove is supplied with an approx. 2m long connecting cable with a Euro-plug.
This cable is to be connected to a 230Volt/50Hz socket. The average electrical
power consumption is some 20 Watt in heating operation. And approx. 270
Watt during automatic ignition. The connection cable must be laid so that there
is no contact to any sharp edges or hot surfaces of the stove.