4 . C L E A N I N G A N D M A I N T E N A N C E
EN
GL
ISH
28
GENERAL MAINTENANCE
Your AMATO appliance has been designed
by our development team with the
concepts of minimum maintenance and
long operating life very much in mind.
Certain cleaning operations and the checkin
of seals are necessary from time to time.
The time between inspections depends to
a large extent on the quality of the wood
you burn and frequency of use.
All maintenance and cleaning work must be
undertaken exclusively when the appliance
has completely cooled down.
A REMINDER
Only use wood that has been properly
stored, is dry and untreated.
Use the correct quantity of fuel.
Poor fuel material can more than double the
number of maintenance activities that become
necessary.
SURFACE CONDITION AND
CLEANLINESS
Ceramic
has a very dense, stone-like surfa-
ce with microscopically fine cracks in it.
These cracks can also be visible to some
extent and are a quality feature of a good
ceramic. The only cleaning that is required
is with a damp cloth and, if necessary, using
some washing up liquid.
The
glass
in the doors can be cleaned with
a specially prepared cleaning medium. This
is obtainable from your specialist dealer. If
the glass becomes very severely sooted,
this could be caused through burning damp
wood.
The
black surface
of the appliance is highly
heat-resistant and need only be cleaned
using a cloth (dampened if necessary). If
the surface needs to be restored, then use
only the original type of lacquer as stocked
by your specialist dealer.
CONVECTION AIR OPENINGS
Clean off dust deposits from the convec-
tion air openings regularly, using a source of
suction.
Before the start of a new heating season,
the appliance should be thoroughly clean-
ed in order to avoid strong odours during
operation.
CLEANING THE FLUE GAS PATHS
(Once per year)
SMOKE FLUE/HEAT EXCHANGER
(Figs 15, 16, 17)
Remove the cleaning and inspection flap.
This opening enables good access to the
flue gas passages. Any deposits of soot and
dust can be brushed off and sucked away.
At the start and finish of a heating period,
check the seals on the combustion chamber
door (Fig. 5) and on the ash drawer.
If the seals are damaged or very worn, then
please order the appropriate replacement
items.
Only intact seals will guarantee the proper
functioning of your firing appliance. Loose
seals should be reattached using Thermohit
seal adhesive.
Содержание AMATO
Страница 1: ...D i e S e e l e I h r e s H e i m e s R I K A K A M I N F E N M A N U A L A M AT O A M AT O B A C K...
Страница 2: ...Fig 1 Fig 2...
Страница 3: ...Fig 5 Fig 4 Fig 3...