Rigol DG811, Руководство пользователя

Страница: 123 / 148

Chapter 2 Front Panel Operations RIGOL
DG800 User's Guide 2-93
To Set the LAN Parameters
Press Utility

Interface

LAN to open the LAN parameters configuration
interface as shown in the figure below. You can view the network status and
configure the network parameters.
Figure 2-26 LAN Setting Interface
Network Status
Different prompt messages will be displayed based on the current network status.

Connected: indicates that the network connection is successful.

Disconnect: indicates that the network connection is failed.

Adapter not found: indicates that the network is not connected.
IP Configuration
IP configuration mode can be DHCP, AutoIP, or ManualIP. In different IP
configuration modes, the configurations for the IP address and other network
parameters are different.
1. DHCP

In DHCP mode, the DHCP server in the current network assigns the network
parameters (e.g. IP address) for the signal generator.

Tap the DHCP parameter selection field to select "On" or "Off" to turn
DHCP mode on or off.
2. AutoIP

In Auto IP mode, the generator acquires IP address within the range from
169.254.0.1 to 169.254.255.254, and gets the subnet mask 255.255.0.0
automatically according to the current network configuration.

Tap the AutoIP parameter selection field to select "On" or "Off" to turn the
AutoIP mode on or off. When DHCP and AutoIP modes are turned on at the