Rigol DG800 Series, Руководство пользователя

Страница: 103 / 148

Chapter 2 Front Panel Operations RIGOL
DG800 User's Guide 2-73
Store and Recall
DG800 can store the current instrument state and user-defined Sequence waveforms
in the internal or external memory. You can recall them when needed. DG800 can
also seamlessly interconnect with
RIGOL
's oscilloscopes that support USB-TMC;
rebuild and output the waveform data collected by the oscilloscope losslessly.
Press Store on the front panel or tap the icon in the information setting area at
the lower-right corner of the user interface to enable the Store/Recall function and
open the Store/Recall interface as shown in the figure below.
Figure 2-18 Store and Recall Interface
Storage System
DG800 can store the current instrument state and user-defined Sequence waveforms
in the internal or external memory. You can recall them when needed. DG800
provides an internal non-volatile memory (Disk C) and an external memory (Disk D).
1
．
Disk C: You can store instrument states and Sequence waveform files (created
by users or downloaded through remote commands) to Disk C. Also, you can
copy the files from Disk C to the USB storage device.
2
．
Disk D: available when the USB storage device is detected by the rear-panel
USB HOST interface.
You can store state files or arbitrary waveform files to Disk D. The number of the
files that can be stored is determined by the storage capacity of the USB storage
device.
The Csv files and Bmp files stored in the USB storage device can also be read.
Note: DG800 can only identify the file whose filename is named in the filename
input interface. If other characters are used to name the file, the name might not be
normally displayed in the store and recall interface.