RightClick AL Plus Series, Система сигнализации автомобиля

Страница: 11 / 17

4-Pins Switch Setting
J1 Setting of Flash or No Flash
The system has been set to the mode of flash at factory (i.e. namely the lights flash or not when opening
a car door).
J2 Setting of Electrica/Pneumatic Lock
The system has been set to electric lock at factory with 0.5sec of output time of the central lock (Switch
PIN2 is in UP position). If it is set to Pneumatic lock, the output time of the central lock will be 3.5sec
(Switch PIN2 is in DOWN position).
J3 Setting of Window Rise / No Window Rise
The system has been set to the mode of window rise at factory (namely closing the windows or not in the
state of theft protection).
J4 Setting of Automatic Arm/NO Arm
The system has been set to the mode of no automatic arm at factory ( namely the system gives alarm or
not when closing the car doors after the stop of the engine).
ATTENTION: We always suggests installation be performed by a certified and trained installation technician, professional
installation is a requirement to obtain full warranty. This wiring information is being provided free of charge and on an ‘as
is’ basis, without any representation or warranty to the products being installed. It is your responsibility to insure proper
installation. We assumes no responsibility with regards to the accuracy or currency of this information.
Proper installation in every case is and remains the responsibility of the installer. We assumes no responsibility resulting
from an improper installation, even in reliance upon this information. Any harm or injury to the installer is in no way the
responsibility of ours. Any damage to the vehicle during installation or after installation is not the responsibility of ours.
page 11