Page 5 OF 8
K&A Manufacturing
6703 Zinser Street Schofield, WI 54476
Phone: 800.298.4351
Fax: 866.882.9475
www.raproducts.com
Step 3:
Place the left leg assembly
3
on the work-
surface
1
inserting the hex rod
4
into the hex drive
near the top of the inner column. Align the pilot holes
on the worksurface support with the pilot holes in the
worksurface. Attach it with (4) wood screws
5
in the
outside corners of the worksurface support. Leave the screws loose by about 1/8" until the
cross support is installed.
Step 4:
Align the holes in the u-channel
10
with the pilot holes in the worksurface. Attach
the u-channel with (8) or (10) wood screws
5
. Fully tighten.
Instruction # 53520
3
2
1
Worksurface
Support
Steps 3 & 4
4
5
5
Detail A
A
Remove these two screws
if you want to change the
crank to the left hand side
of the table and insert the
hex rod into the front of the
left leg
3
.
