Right Weigh 201-EBT-04, Руководство по установке и эксплуатации

Страница: 11 / 32

SCALE INSTALLATION
& ELECTRICAL CONNECTIONS
11
DO NOT connect directly to a battery or any constant power source, gauge
should be connected to a switched source so that it can be disconnected
from power when not in use. Most users connect the power to vehicle
marker lights or the AUX/ABS wire.
Electrical connections MUST be insulated, see Appendix B for instructions.
The two unterminated wires coming out of the harness are used to power the
scale. Connect the RED
wire to a switched positive (+) power source and the
BLACK wire to chassis ground (-). The required supply voltage must be between 9
and 32 volts DC. For more information on wiring connection and insulation, see
Appendix B.
!
INSTALL POWER CABLE 7
Insert the male connector on the harness onto the female connector on the back
of the scale. Make sure to orient the connector properly so that the small cutout
on both connectors line up. Once the connector has been pressed in, thread the
collar into the scale until it is hand tight.
BLACK = GROUND
RED = POWER
CONNECTION HARNESS
The MSU’s MUST be connected to a switched power source that is on when
the ignition is on. For trailers, use the AUX/ABS wire. For tractors, an ignition
accessory wire must be located. Verify that power is switched with the
ignition after installation. For more information on TCA requirements, refer
to pages 7-8.
TCA OBM Requirement:
If using the
Remote Sensor Feature , stop these
instructions at this time and follow the
instructions on the 403-SK installation manual
to finish product installation.