wifi-nSTEP Instructions
Copyright Rigel Systems 2010
Page 7 of 12
www.rigelsys.com
TOP LEVEL DISPLAY
1) Shows current position (P=)
2) Stepping type (Half, Wave, Full), Wave
shown
3) Coils On, Off after move (0 or 1) 1 = Coils
Off shown
4) Stepping phase selected (0, 1 or 2) to
match motor wiring, 0 = phase select
shown
5) Current Temperature reading
6) Current Speed selected on slider (=0146
steps/second)
Stepper Controls
1)
Menu button
: press to cycle through the top
level menus
2)
SMenu button
: Press to cycle through sub-
menus for current top menu’s
3)
F+ button:
Use for Focus on top level menu,
4) selections on sub menu’s
5)
F- button
: used for focus on top level menu,
selections on sub menu’s
6)
Slider
– move left to go slower, right to go
fast, will only go as fast as Max Speed allows
(see below under Motor Setup)
NOTE
There is a “deadman” timer of 10 seconds
on F+ and F- presses, so if wifi connection
is lost, stepper does not continue to move
after 10 seconds. As a result if you press
F+ or F- for longer than 10 seconds, you will
have to release and press again to continue
the focus change.
Please consult the wifi-nSTEP manual for
additional information on commands.
Menu Tree
0 Top Level
1 Display Setup
-Brightness
-Backlight Always On
-Backlight On Time
-Set Slider Max Speed
- Contrast
2 Goto Position
-0:SXXXXXX GoTo=I
-1:SXXXXXX GoTo=I
-2:SXXXXXX GoTo=I
-3:SXXXXXX GoTo=I
-4:SXXXXXX GoTo=I
3 Save Position
-Confirm Zero U/D=Y
-0:SXXXXXX
-1 “
-2 “
-3 “
-4 “
4 Motor Advanced
- Set stepping
-Set coils On/Off
-Set phase
5 Temp Setup
- Temp Delta
-Temp Move
-Temp Backlash
-Internal Temp Compensation Mode
-Do Temp Compensation
