TECHNICAL ASSISTANCE SERVICE
27
Once you have completed all the preparatory steps,
proceed as follows to start up the boiler for the first time:
- If the system is equipped with a temperature controller
or timer thermostat, make sure that it is switched ON
- Adjust the timer thermostat/s or temperature controller
to the desired temperature (~20°C)
- Turn the system’s main power switch ON
- Adjust the boiler thermostat on the control panel
- Turn the control panel power switch ON (1) and make
sure that the green power indicator (if fitted) lights.
The burner should now ignite and remain in operation
until the set temperature is reached.
If any ignition faults or malfunctions occur, the burner
performs a “LOCKOUT SHUTDOWN”. This is shown by
the red button light on the burner and by the warning light
on the control panel.
b
If a “LOCKOUT SHUTDOWN” occurs, wait about 30
seconds before resetting the burner.
To reset the burner, press the red button light on the
burner and wait until the flame ignites.
Repeat this operation 2-3 times at the most. If the prob-
lem persists, perform the following checks:
- All checks listed in the burner's own instruction manual;
- All steps listed in the ‘Preparing for Initial Start-up’ sec-
tion;
- All the electrical connections shown on the control
panel wiring diagrams.
INITIAL START-UP
20
40
60
80
100
0
120
20
40
60
80
100
0
120
