Riello EMME 1400, Инструкции по установке, использованию и обслуживанию

Страница: 38 / 88

2915041
4 GB
MINIMUM GAS PRESSURE - MAXIMUM POTENTIAL
(gas with Pci 8600 kcal/m
3
)
Pressure: measured at pressure socket 12)(Fig. 2) with the combustion chamber at 0 mbar.
MOUNTING THE BURNER ON THE BOILER
To detach the burner from the combustion head, proceed as follows:

Remove the cover from bracket 1), pin 2), stops 4) and screws 3)

Detach hoses 6)

Release the tie-rod on the gas butterfly, removing screw 11)

Remove screw and plate 12), pins 13) and 14) and slide out lever 15)

Slide the burner out of the combustion head by about 100-120 mm, and release the drive fork 7) by removing screws 10);
remove the two electrical wires from the terminal strip 18)

It’s now possible to slide the burner fully out on pins 5)

Secure the tube to the boiler, inserting the insulating screen 9)

Slide the burner in on pins 5), leaving it open by about 100-120 mm

Refit fork 7), securing it with screws 10); refit the two electrical wires into the terminal strip 18)

Completely close the burner, securing it with screws 3), fit stops 4), pin with cotter 2), gas butterfly tie-rod 11) and hoses 6)

Slide in lever 15), securing it to tie-rod 16), replace pins 13) and 14) and reclose the hole with plate and screw 12)

When the burner is open, it is possible to detach gas sleeve 8) from the tube

Before fitting the burner to the boiler, it is advisable to fit the tube as specified below.
NB: by lifting the burner with hooks, it is possible to secure it to the boiler without detaching it from the head.
Fig. 4
S7965
Pr
essure -
mbar
Fig. 5
S7963
100 ÷ 120 mm