2
GENERAL INFORMATION
This manual, Code Doc-0071233 - Rev. 3 (09/2017)
comprises 8 pages.
GENERAL INFORMATION
RANGE
MODEL
CODE
RIELLO 7200/3F - 800 HV PLUS
20136273
RIELLO 7200/3F - 1000 HV PLUS
20136274
RIELLO 7200/3F - 1500 HV PLUS
20136275
RIELLO 7200/3F - 2000 HV PLUS
20136277
RIELLO 7200/3F - 3000 HV PLUS
20052788
ACCESSORIES
For a complete list of accessories and details of their compatibil-
ity, refer to the Catalogue.
Dear heating engineer,
We would like to congratulate you on having recommended a
R
storage cylinder unit: a modern product that's capable of
ensuring a high degree of reliability, efficiency, quality and safe-
ty.
While your technical skills and knowledge will certainly be more
than sufficient, this booklet contains all the information that
we have deemed necessary for the device's correct and easy in-
stallation.
Thank you again, and keep up the good work,
Riello S.p.A.
CONFORMITY
The
R
solar heaters comply with DIN 4753-3 and UNI EN 12897.
CONTENTS
The following symbols are used in this manual:
9
CAUTION! =
Identifies actions that require caution and
adequate preparation.
0
STOP! =
Identifies actions that you MUST NOT do.
1
GENERAL SAFETY INFORMATION
9
Check that the product is complete, undamaged and as or-
dered as soon as you receive it. Report any discrepancies or
damage to the
R
dealer who sold it.
9
This product must be installed by a legally qualified heat-
ing engineer. On completion of the installation, the install-
er must issue the owner with a declaration of conformity
confirming that the installation has been completed to the
highest standards in compliance with the instructions pro-
vided by
R
in this instruction manual, and that it con-
forms to all applicable laws and standards.
9
This product must only be used for the purpose for which it
is designed and made, as specified by
R
.
R
declines
all responsibility, contractual or other, for damage to prop-
erty or injury to persons or animals caused by improper in-
stallation, adjustment, maintenance or use.
9
The product must be serviced at least once a year. Servicing
must be arranged in advance with the
R
Technical Assis-
tance Service.
9
All servicing and repairs must be performed by a qualified
heating engineer.
9
If water leaks from the storage cylinder, turn off the water
supply and contact
R
’s Technical Assistance Service or a
qualified heating engineer immediately.
9
If the product is not going to be used for an extended peri-
od of time, contact the manufacturer’s Technical Assistance
Service to have at least the following operations performed:
− Close the shut-off cocks for the domestic hot water circuit
− Shut down the boiler connected to the storage cylinder
as instructed in its own manual
− Switch the storage cylinder OFF at the control panel (if
fitted) and at the mains power switch
− Drain the central heating circuit and domestic hot water
circuit if there is any risk of freezing.
9
This instruction manual is an integral part of the product. It
must be kept safe and must ALWAYS accompany the product,
even if it is sold to another owner or transferred to another
user or to another installation. If you lose this manual, or-
der a replacement immediately. Keep the product purchase
documents to be presented to the
R
authorised Technical
Assistance Service to request a service call under warranty.
This manual, Code
- Rev.
comprises
pages.
ENGLISH
General information
General Safety Information . . . . . . . . . . . . . . . . . . . . . . 2
2 Precautions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Description of the appliance . . . . . . . . . . . . . . . . . . . . . 3
Identification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
System layout . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Technical specifications. . . . . . . . . . . . . . . . . . . . . . . . . 4
Unpacking the product . . . . . . . . . . . . . . . . . . . . . . . . . 5
Installing the magnesium anodes. . . . . . . . . . . . . . . . . 5
Fitting the insulation (models 2000 - 3000). . . . . . . . . . 5
Place of installation . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Installation in older systems and systems requiring
modernisation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Water quality requirements. . . . . . . . . . . . . . . . . . . . . . 6
Water connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Recycling and disposal . . . . . . . . . . . . . . . . . . . . . . . . .8
15 Start-up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
Temporary shutdown . . . . . . . . . . . . . . . . . . . . . . . . . .8
Preparing for extended periods of disuse . . . . . . . . . . .8
External maintenance. . . . . . . . . . . . . . . . . . . . . . . . . .8