RIDGID R48607, Руководство оператора

Страница: 23 / 104

23 - English
0
30
15
22.5
33
.9
0
15
22.5
 Place the workpiece flat on the miter table with one edge
securely against the fence. If the board is warped, place
the convex side against the fence. If the concave edge
of a board is placed against the fence, the board could
collapse on the blade at the end of the cut, jamming the
blade.
See Figures 41 - 42.

When cutting long pieces of lumber or molding, support
the opposite end of the stock with a roller stand or with
a work surface level with the saw table.
See Figure 35.

Align cutting line on the workpiece with the edge of saw
blade or LED shadow.

Grasp the stock firmly with one hand and secure it against
the fence. Use the work clamp or a C-clamp to secure
the workpiece when possible.

Before turning on the saw, perform a dry run of the cut-
ting operation to make sure that no problems will occur
when the cut is made.

Grasp the saw handle firmly. Squeeze the switch trigger.
Allow several seconds for the blade to reach maximum
speed.

Slowly lower the blade into and through the workpiece.

Release the switch trigger and allow the saw blade to
stop rotating before raising the blade out of workpiece
and removing the workpiece from the miter table.
TO BEVEL CUT
See Figures 32 and 33.
A bevel cut is made by cutting across the grain of the
workpiece with the blade angled to the workpiece. A straight
bevel cut is made with the miter table set at the zero degree
position and the blade set at an angle between 0° and 48°
on the left side and 0° or 45° on the right side.
NOTE: It may be necessary to adjust or remove the sliding
miter fence to insure proper clearance prior to making the
cut. The maximum bevel cut to the right side is 45° to insure
proper clearance.
 Slide the saw head to its most rearward position and
tighten the slide lock knob securely.

Pull out the lock pin and lift saw arm to its full height.
 Lift the miter lock lever, then depress and hold the detent
release button to release the miter table.

Rotate the control arm until the scale indicator aligns with
zero on the miter scale.

Release the detent release button, then push the miter
lock lever down to secure the miter table.

Loosen the bevel lock knob and move the saw arm to the
desired left bevel angle.
NOTE: To obtain right bevel angles, pull the bevel stop
pin out and tilt the saw to the desired right bevel angle.

Left bevel angles can be set from 0° to 48°. Right bevel
angles can be set from 0° to 45°.
OPERATION
Fig. 32
BEVEL CUT
WORK CLAMP
Fig. 33
BEVEL STOP TURRET
ADJUSTMENT AT 45º
BEVEL
LOCK KNOB
BEVEL STOP
PIN
45º
33.9º
48º
BEVEL STOP TURRET
BEVEL STOP
ADJUSTMENT
SCREW