MAKING ADJUSTMENTS
FIGURE 30
ADJUSTING THE BLADE HEIGHT
1.
For all through cuts, the top of the blade points should be
above the workpiece and the bottom of the blade gullets
are below the top surface of workpiece.
2.
For non-through cuts, the top of the blade points should be
set to the depth of the cut.
3.
To adjust the height of the blade, refer to Figure 30 and do
the following:
4.
Make sure the bevel locking lever
B
is in the locked
position.
5.
Adjust the blade height by turning the bevel wheel.
Clockwise will raise the blade and counterclockwise lowers
it.
CHANGING THE BEVEL
See Figure 30.
1.
Unlock the bevel locking lever
B
by pulling it into the
unlock position.
2.
Holding knob/wheel
A
, slide the bevel indicator to the
desired angle.
3.
When the blade is at desired angle, lock the bevel locking
lever
B
by pushing it down to the lock position.
FIGURE 31
FIGURE 32
USING THE MITER GAUGE
OPERATION AND ADJUSTMENT
OF RIP FENCE
There are two miter gauge grooves. One on either side of the
blade. When making a 90º cross cut, use either groove. For
beveled cross cuts use the groove on right so that the blade is
tilted away from miter gauge and hands.
• Loosen the miter gauge lock knob
A
. Rotate the gauge until
desired angle on scale is reached. Re-tighten lock knob
A
.
See Figure 31.
NOTE:
The miter gauge has index points at 90, 75, 60, 45, & 30
degrees both left and right.
To reduce the risk of injury, always make sure the rip fence is
parallel to the blade before beginning any operation.
1.
Make sure both the front and rear side of fence are 10
inches away from the blade.
2.
If not accurate, use the Combination 4mm Allen Wrench/
Phillips Screwdriver
HP9
to loosen the screws for both front
& rear tabs.
3.
Adjust the fence to proper position and make sure the
fence is parallel to the blade, then tighten the screws for
the tabs.
4.
Place the fence on the Orange tabs (read the orange scale,
the pointer indicates 10 inch).
5.
For Black tabs (right 0 inch ~15 inch) and Orange tabs (left
0 inch ~12 inch), repeat the same adjustment as above.
UNLOCK
UNLOCK
LOCK
LOCK
B
A
A
23
