ASSEMBLY
To reduce the risk of serious injury:
1.
The Riving Knife must be installed for every through cut
and for every non-through cut unless the Riving Knife
A
would interfere with the cut.
2.
The Riving Knife provided with the Table Saw shall be
thicker than the body of the matching Saw Blade provided
with the Table Saw but thinner than the kerf width of that
Saw Blade.
3.
ALWAYS use a Blade with the correct thickness to match
the Riving Knife. (0.10 inch (2.6mm) min. kerf width and
0.073 inch (1.85mm) max body thickness).
4.
The Riving Knife must be securely positioned in the “up” or
“through cut” position when using the Anti-Kickback Pawls
and Blade Guard Assembly.
5.
Make sure the Riving Knife is properly aligned to the Blade.
See RIVING KNIFE POSITION AND ALIGNMENT,
Page 26.
FIGURE 11
FIGURE 12
A
A
A
A
A
A
A
A
PC7
PC7
THROUGH CUT
POSITION
LOCK
LOCK
POSITION
POSITION
FIGURE 10
A
THROAT PLATE
1.
To install Throat Plate
PC15
, lower Blade below Tabletop,
then carefully feed
the Throat Plate, slotted end first, from
the rear of the Table to the front, keeping the Blade
centered within the slot on the Throat Plate. See Figure 11.
The Throat Plate should rest within the cavity in the
Tabletop.
2.
Ensure that the Throat Plate is flush with the top of the
Table.
3.
If the Throat Plate is not flush with the Tabletop, adjust the
height of the Throat Plate using the four Set Screws
A
.
NOTE: For leveling the throat plate see page 20.
4.
To remove Throat Plate, lower Blade below Tabletop, then
carefully slide the throat plate out from the front of the
table to the rear, using the cutout on Figure 12.
NOTE:
If Throat Plate is not flush with the Table Top the Anti-
Kickback Pawls can interfere with the Blade adjustment.
16
17
