RIDGID R4092, Руководство оператора

Страница: 36 / 116

36 — English
ADJUSTMENTS
ALIGNING THE LASER GUIDE LINE
See Figure 59.
DANGER:
Laser radiation. Avoid direct eye contact with light
source.
WARNING:
Use of controls or adjustments or performance of
procedures other than those specified herein can
result in hazardous radiation exposure.

Using a straight edge or square, draw a mark on the tile
with a marker or grease pencil.
 Lock sliding table and secure frame.

Place the material on the table and firmly against the miter
guide and fence.
 Plug the saw into the power source and make a slight
cut to score the tile.

When the cut is made, turn the saw OFF . Wait for the
cutting wheel to come to a complete stop.

Roll sliding table away from cutting wheel.

Turn on the laser.
HORIZONTAL
ADJUSTMENT
SCREW
BRACKET
ANGLE
ADJUSTMENT
SCREW
LOCK
SCREW
Fig. 59
To adjust the laser angle:

Loosen the lock screw a 1/4 of a turn so the laser can be
adjusted.
NOTE: Do not remove the lock screw.

Using the 5 mm end of the hex key, rotate the angle ad-
justment screw. The laser angle will rotate in the same
direction as the screw.

Rotate the laser angle clockwise or counter-clockwise
until properly aligned with the cut in the tile.

Once aligned, tighten the lock screw.
To adjust the laser left or right:

Loosen the horizontal adjustment screw on the laser
bracket.

Move the laser bracket left or right until the laser is properly
aligned with the cut in the tile.

Once aligned, tighten the adjustment screw, then close
and lock the wheel guard.
NOTE: Always make practice cuts on scrap material before
cutting through your workpiece.