OPERATION
9
ON/OFF SWITCH (Fig. 5)
With the Battery Pack engaged onto the Wet/Dry Vac
Battery Pack Receptacle, turn the Vac “ON” by pressing
in on the “I” (top) ON/OFF Switch. To turn “OFF”, press
the “O” (bottom) on the ON/OFF Switch. The symbols
used on the Switch Actuator are international “ON &
OFF” symbols.
= ON
= OFF
SWEEP
ON/OFF Switch
CO
RD
LE
SS
Fig. 5
WARNING:
To reduce the risk of fire, explosion, or damage to Vac:
• Do not leave Vac running while unattended - you may fail to notice important signs indicating abnormal
operation such as loss of suction, debris/liquid exiting the exhaust, or abnormal motor noises.
Immediately stop using Vac if you notice these signs.
• Remove battery pack when not in use.
• Do not continue running when float has cut off suction.
• Sparks inside the motor can ignite airborne flammables. Do not operate Vac near flammable
liquids or in areas with flammable gases, vapors, or explosive/airborne dust. Flammable liquids,
gases, and vapors include: lighter fluid, solvent-type cleaners, oil-based paints, gasoline, alcohol,
and aerosol sprays. Explosive dusts include: coal, magnesium, aluminum, grain, and gun powder.
• Do not vacuum up explosive dusts, flammable liquids, or hot ashes.
• Do not leave sawdust or rags with stain or polyurethane residue inside Vac. Empty drum after picking up
these potentially self-heating materials.
WARNING:
To reduce the risk of electric shock or injury:
• Do not expose to rain or allow liquid to enter motor compartment. Store indoors.
!
!
CAUTION:
To reduce the risk of hearing damage, wear ear protectors when using the
Vac/Blower for extended time or in a noisy area.
!
NOTE:
Use only a RIDGID 18 V Battery Pack.
The HD03180 will operate with the Batteries listed in the
“Battery Pack Installation” section.
NOTE:
Your Cordless Wet/Dry Vac will operate on
one battery only. For best performance, install one
Fully-Charged Battery Pack before beginning operation.
Minimum recommended Battery Capacity is 4.0Ah per
Battery Pack.
- Make sure Vac is turned OFF (O).
- Insert Battery Pack, as shown in the “Battery Pack
Installation” section.
- Make sure the Battery Pack Release Buttons snaps
into place and the Battery Pack is secure before
beginning operation.
- Depress the Battery Pack Release Buttons to
remove the Battery Pack.
SP7126 HD03180 2022 ESF.indb 9
SP7126 HD03180 2022 ESF.indb 9
6/2/22 11:46 AM
6/2/22 11:46 AM
