47
Once the trailing end is on the table:
When “width of rip” is 2” or wider, use the push stick to
finish the work all the way past the blade.
When “width of rip” is narrower than 2” the push stick
cannot be used because the guard will interfere...use the
auxiliary fence and push block.
Attach auxiliary fence to rip fence with two “C” clamps.
Feed the workpiece by hand along the auxiliary fence
until the end is approximately 1” past the front edge of the
table. Continue to feed using the push block.
Hold the workpiece in position and install the push block
by sliding it on top of the auxiliary fence/work support
(this may raise guard).
Push Stick
Auxiliary
“C” Clamp
Fence
Push Block
Workpiece
Auxiliary Fence
