Ride Best 2009 WAROO, Руководство пользователя

Страница: 13 / 14

13
How do I replace worn bridles on my Waroo?
The Waroo front bridle has user-replaceable heavy duty inserts fitted at two points; within the VP2 bridle
section (detailed in grey), and also for the upper floating pulleys (detailed in red). Should these become
worn, simply undo the retaining loops at
either end and fix in place a replacement
set. It is recommended that you replace
both sides, left and right at the same time
even if only one side is showing wear.
Thread the lines through the pulleys
according to the diagram shown and
carefully cinch up the larkshead knots.
After replacing the VP2 bridle lines,
always ensure that you have someone to
assist you in launching the kite. With the
kite held into the wind by your assistant,
check the depower action of the front
bridle by moving the bar up and down.
Do not launch the kite if the depower does not
function correctly
Start by fastening the pulley line around
the front line attachment pigtail (short blue
section) with a larkshead knot. Then thread the line over and through the top VP2 pulley and then back
down through the lower pulley and out to wingtip bridle attachment. Always check the correct fitment of
replacement VP2 lines before flying the kite, and use an assisted launch to enable safe checking of the
depower system the first time you launch after refitting any bridle sections.
To replace the upper floating pulley line, simply un-loop both ends of the line shown in red, thread a new
line through the pulley and cinch up the retaining knots on each end.
Inflation:
Best Kiteboarding kites are shipped with a hand operated pump. We selected these pumps because it is very difficult to
over inflate the kite with a manual pump. Your Waroo should be inflated to between 10-11PSI.
Best Kiteboarding will not be responsible for any damage that occurs due to the use of a pressure hose/compressor when
inflating your kite
RED-LINE BAR CONVERSION KIT 2009
The 2009 Red-line bar is the first Best
Bar to use an equal front and rear line
calibration, with the bar at the max-
power position the front and back lines
are of equal length. This will be the
standard bar calibration for all future
control bars from Best.
The Red-line Bar and the Kahoona kite
are the only 2009 products that are
set-up for this calibration; this means
that when using a Red-line Bar with a
Waroo, Nemesis-HP or Guroo kite the
user must also use the 'Red-Line Bar
Conversion Kit'. The conversion kit is a
pair of pigtails that, when added to
your flying lines, compensate for the
difference in length between the Red-
line Bar and the 2009 Best Bar.
To use your Red-Line Bar with a
Guroo, Waroo or Nemesis-HP follow
the instructions below to extend your
rear flying lines by adding a conversion
kit pigtail to each rear flying line.