Ridder HortiJet-Go!, Инструкция по установке и эксплуатации

Страница: 15 / 64

Depending on the configuration, the following sensors can be added:
EC sensor: the EC sensor measures the concentration of fertilizers in the water.
pH sensor: the pH sensor measures the acidity level of the water.
You can have zero, one or two sensors of both types. The HortiJet-Go! is supplied
without sensors as standard.
If there is one EC / pH sensor: this is the control sensor.
If two EC / pH sensors are present: the verification sensor checks the
functioning of the control sensor.
On the HortiJet-Go!, the positions of the sensors for the HortiJet Pro are capped.
Please consult the supplied OEM manuals for the correct use and maintenance of the
relevant components.
2.3.5 I/O modules
The HortiJet-Go! uses I/O modules called Smart Switches. Smart Switches are the
(manual control) switches used for the HortiMaX-Go! process controller. These
switches feature an electrical circuit, a processor and software.
The following table below provides an overview of the different types of I/O modules:
Module type When relevant
Smart Switch
Weather/Alarm Always.
Smart Switch System
pump HortiJet Always.
Smart Switch EC If fertilizers are dosed based on an EC measurement.
Smart Switch Fertilizer If fertilizers are dosed based on quantity (EC
measurement is optional).
Smart Switch pH If acid is dosed based on a pH measurement.
The 'EC’ and 'Fertilizer’ Smart Switches are also equipped with an input for a
flow meter. Both Smart Switches are available in two versions:
1. Suitable for the signal from a flow sensor (GF15)
2. Suitable for the signal of a water meter (based on pulses)
Other types of Smart Switches are not part of the HortiJet itself, but can be supplied
as accessories.
HortiJet-Go!
15