32DSSK03.B
2 - 4
D. CONTROLS AND INDICATORS
WARNING
THE LIFT CAN OPERATE ONLY WHEN PERMITTED TO BY THE VEHICLE INTERLOCK
CIRCUITRY. IF NECESSARY, REFER TO VEHICLE OPERATOR MANUAL FOR
INTERLOCK INSTRUCTIONS. DO NOT OPERATE LIFT WITH INTERLOCK BYPASSED.
CONTROL PENDANT
Refer to
Figure 2-5.
The lift is operated with two rocker switches on a hard-wired, hand-held
remote control pendant. Control platform movement by pushing and holding one end of a
rocker switch. The ends of the switches are referred to in this manual as buttons.
Pushing the DEPLOY button causes the platform to unfold at floor level. Pushing the DOWN
button causes the platform to descend towards the ground. Pushing the UP button causes
the platform to rise towards floor level. Pushing the STOW button when the platform is at floor
level causes it to fold and retract into the vehicle.
Platform motion can be halted at any time by releasing the button. The pendant is usually
stored on a wall clip in an interior location that is near the lift.
CONTROL SWITCH
Refer to
Figure 2-6
on the following page. An alternate lift control switch is located on the left
side platform armrest. The spring-loaded switch lever can be used by the passenger to control
UP and DOWN motions of the platform. To move platform downward push and hold switch lever
forward, and to move platform upward pull and hold lever back. Release lever at any time to halt
motion.
FIGURE 2-5: CONTROL PENDANT
STOW
DEPLOY
UP
DOWN
STOW
BUTTON
DEPLOY
BUTTON
UP
BUTTON
DOWN
BUTTON
