3
1.
Depress the spring clip in the middle stem
and insert it into the top stem(1) aligning
the clip with the hole.
2.
Loosen the middle stem’s lock nut in
the direction of the arrow. Then
insert the lower stem (2) into the
middle stem. Turn the stem’s lock nut in
the reverse direction of the arrow to lock
it in place.
3.
Unscrew the bolt of the control box(3) and hitch the control box to the
top stem. Then, insert the bolt into the assembly hole on top stem and
tighten it with the box.
4.
Wind the cable around the stem. Insert
the search coil cable plug into the five
pin jack at the bottom of control box’s
housing.
5.
When you stand upright with the detector in your hand, the search coil
is level with and about 0.5~2 inches / 1~5cm above the ground. You
can lengthen or shorten the stem basing on your height. After figuring
out the suitable length, then tighten the lock nut.
Caution:
The search coil cable plug fits into the connector only one way. Do not
force the plug or you could damage it.
ADJUSTING THE SEARCH COIL
Loosen the knobs at the search coil’s end, then adjust the search coil to the