Ricoh VB2807800, Инструкция по эксплуатации, копия для справок

Страница: 46 / 76

Troubleshooting
40
3
❖
Duplex
When Memory Is Full
Problem Causes Solutions
Order of copies is not cor-
rect. You set originals in the in-
correct order. When setting a stack of originals in
the ARDF, the last page should be
on the bottom.
If you set an original on the expo-
sure glass, start with the first page
to be copied.
In Duplex Margin mode,
parts of the original image
are not copied. The margin is too wide. Set a narrower margin with User
Tools. You can set the width be-
tween 0-50 mm (0"-2"). See p.53
“Duplex Margin”.
There is a lack of margin
space on the opposite side
of the binding position.
When using Duplex, copy
is made Top to Top even
though Top to Bottom is se-
lected. You placed the originals in
the wrong orientation. Place the originals in the correct ori-
entation. See p.16 “Original Orien-
tation”.
Messages Causes Solutions
Memory is full. [Print] scanned
orig., [Clear] to cancel/clear
memory.
[ Clear ] [ Print ]
Note
❒
Copying will stop and this message will be
displayed when the memory is full.
The scanned original
exceeds the number
of pages that can be
stored in memory. Press [ Print ] to copy
scanned originals
and cancel the scan-
ning data. Press
[ Clear ] to cancel the
scanning data and
not copy.
Reset * orig., then press
[Resume] to scan and copy the re-
maining originals.
[ Stop ] [ Resume ]
The machine checks
if the remaining orig-
inals should be cop-
ied, after the scanned
original has been
printed. To continue copying,
remove all copies,
and then press
[ Resume ] . To stop
copying, press [ Stop ] .