Ricoh SR5090, Руководство по обслуживанию на месте

Страница: 46 / 107

1.Detailed Descriptions
42
the near-end status is notified to the machine.
To correctly count the actual remaining number of staples, instruct the customer to do as follows:
•
Replace the cartridge after the staples have completely run out (End).
•
Replace the cartridge with the machine’s power on (so that the device status can be monitored).
What if the counter does not match the actual remaining number of staples?
•
After replacing the cartridge, set SP6-795-002 / SP6-796-002 (Staple N.E. Setting: Staple
Remaining Setting) to the maximum value.
•
If some degree of mismatch is tolerable, change the value according to the estimated number of
remaining staples in the new cartridge.
Automatic Counter Reset
After reaching the near-end status, if the staples do not run out (End) even after the number of staples
used exceeds 1.5 times that of the specified number of staples in the near-end status, the counter is
automatically reset according to the determination that the staples have been replaced. The automatic
counter reset function can be set on/off on the corresponding SP.
SP6-796-003/007 (Staple N.E. Setting: Anomaly Near-End Disp. Clear Setting)
0: Reset
1: Do not reset
Saddle Stitching (Booklet Stapling)
New Type of Saddle Stitching
Compared to the standard center stapling, the type done by this finisher can reduce the bulge at the
center of the booklet.
[A] Standard saddle stitching
[B] Saddle stitching by this finisher