Ricoh Plockmatic SquareBack Trimmer, Руководство оператора

Страница: 31 / 44

CIP Training
Plockmatic SquareBack Trimmer
Troubleshooting
Clearing a jam condition
Jam codes list
Code # Area Cause
507 Infeed Q13 and Q14 (paper path sensors) covered too long.
508 Infeed Q13 and Q14 (paper path sensors) covered after purge.
509 Infeed Q13, Q14 and Q15 (paper path sensors) covered too long.
510 Infeed Q13, Q14 and Q15 (paper path sensors) covered after purge.
511 Infeed Q14 and Q15 (paper path sensors) covered too long.
512 Infeed Q14 and Q15 (paper path sensors) covered after purge.
600 Trimmer Booklet has missed Q15 or did not go past Q15, Q16 or Q17.
601 Align Q15 (paper path sensor) not reached in time.
602 Align Q15 (paper path sensor) covered too long.
603 Align Q15 (paper path sensor) covered after purge.
604 Clamper Q16 (paper path sensor) not reached in time.
605 Clamper Q16 (paper path sensor) covered too long.
606 Align Q16 (paper path sensor) covered after purge.
607 Exit Q17 (paper path sensor) not reached in time.
608 Exit Q17 (paper path sensor) covered too long.
609 Exit Q17 (paper path sensor) covered after purge.
610 Align / Clamper Q15 and Q16 (paper path sensors) covered too long.
611 Align / Clamper Q15 and Q16 (paper path sensors) covered after purge.
612 Align / Clamper Q15, Q16 and Q17 (paper path sensors) covered too long.
613 Align / Clamper Q15, Q16 and Q17 (paper path sensors) covered after purge.
614 Align / Clamper Q16 and Q17 (paper path sensors) covered too long.
615 Align / Clamper Q16 and Q17 (paper path sensors) covered after purge.
616 Stacker Stacker is full.
701 Waste bin Waste bin is full.
If any of the jams listed in the table above is triggered, please follow these guidelines:
•
Open the top covers and remove any booklet stuck in the paper path;
•
Check for misfed sheets and remove them;
•
Check for debris on the paper path and remove them;
•
Check that booklets on the stacker do not block path of exiting booklets;
•
Ensure there are no obstructions in the paper path;
•
Wipe all sensors (do not use any fluid to clean them);
•
Make sure the paper size is set correctly;
•
Power off and power on the machine.
WARNING:
The trim unit has two sharp knives for trimming booklets: do not touch them for
any reason and at any time. If service is needed, call a technician.