Ricoh MP7060A Series, Руководство пользователя

Страница: 13 / 31

6
MP 7060A Series
Make sure that the host computer is turned OFF when connecting or
removing a jumper.
Connect the jumper in the vertical direction as shown in Figure 1. If con-
nected horizontally as shown in Figure 2, the drive may malfunction or be
damaged.
Figure 1 Figure 2.
Only one jumper should be installed on the jumper connector. If more than
one jumper is installed, the drive may malfunction or be damaged.
Master/Slave setting is determined by jumper installation on the Jumper
Connector. The following table shows the possible jumper settings.
Name Function
MA Drive set as Master (factory default)
SL Drive set as Slave
CS Drive mode set by CSEL on the host
IDE interface
A hard disk is normally installed as the Primary Master on the EIDE
(ATAPI) interface. Other EIDE peripheral devices such as hard drives and
CD-ROMs are then set differently.
(Cable Select)
(Master)
(Slave)