Ricoh MP7060A Series, Руководство пользователя

Страница: 12 / 31

5
MP 7060A Series
3. Installing the Drive
3.1 Before Installation
Before installing the drive, please note the following points.
z
You will need the following:
•
A Phillips head screw driver of a suitable size to fit the securing
screws for the drive unit.
•
The manual for the computer, so you can find out the positions for
the IDE controller.
z
Turn off all peripheral appliances of the computer, and the computer itself
, and disconnect their power cords from the wall sockets.
z
Discharge any static electricity by touching the computer covers etc.
z
Record the serial number of the drive unit in the box below.
Serial No.
3.2 Jumper Set Up
Before installation, set the jumper on the jumper connector on the rear panel.
The drive can be connected as the Master or Slave on an EIDE (ATAPI)
interface. When several (up to four) EIDE devices are connected, each must
be set in a unique way. Specific knowledge of hardware and software is
necessary to install the drive.
We cannot guaranty against direct or indirect damage resulting from im-
proper connections. Ask your supplier for details of the installation proce-
dure.
If two peripheral devices with the same settings are both connected to the
Primary or to the Secondary EIDE bus, the host computer may fail to run,
or may malfunction, so careful attention is necessary.
MA: Master
CS: Cable Select
(CSEL)
SL: Slave