Ricoh HL-F1, Руководство по обслуживанию на месте

Страница: 174 / 296

• Selectors 4 and 5: Time-out length for 1st and 2nd dial tone detection
These selectors set the time-out length for the 1st and 2nd dial tone detection so that the machine waits
dial tone input for the specified time length and disconnects itself from the line when no dial tone is
inputted.
WSW09 (Protocol definition 1)
Selector No. Function Setting and Specifications
1 Frame length selection 0: 256 octets 1: 64 octets
2 Use of non-standard commands 0: Allowed 1: Prohibited
3
4
No. of retries
No. 3 4
0 0 : 4 times
0 1 : 3 times
1 0 : 2 times
1 1 : 1 time
5 T5 timer 0: 300 sec. 1: 60 sec.
6 T1 timer 0: 35 sec. 1: 40 sec.
7
8
Timeout for response from the called station
in automatic sending mode
No. 7 8
0 0 : 55 sec. (in U.S.A. and Canadian
models)/ 60 sec. (in other models)
0 1 : 140 sec.
1 0 : 90 sec.
1 1 : 35 sec.
• Selectors 1 through 5 are not applicable in those models which do not support ECM.
• Selector 1: Frame length selection
Usually a single frame consists of 256 octets (1 octet = 8 bits). For communications lines with higher
bit error rate, however, set selector 1 to "1" so that the machine can divide a message into 64-octet
frames.
Remarks: The error correction mode (ECM) is a facsimile transmission manner in which the machine
divides a message into frames for transmission so that if any data error occurs on the transmission line,
the machine retransmits only those frames containing the error data.
5. Service Maintenance
172
5