Ricoh GWD5100, Руководство по эксплуатации

Страница: 88 / 100

• When a paper roll of 90 g/m
2
(24 lb) or 110 g/m
2
(29.3 lb) paper is used and there is little paper
left on the roll, image may be faint near the leading and/or trailing edge, or an image may be
doubled. To prevent this, set 3-5 mm (0.11"- 0.19") margins from the leading and trailing edges.
• p.53 "Anti-humidity Heater Switch"
• “Margin Adjustment”, Copy/Document Server Reference
Cut paper
• Straighten curled or warped paper before loading.
• To prevent multiple-sheet fed simultaneously, fan the paper before loading it in the tray.
• Do not load paper over the limit mark of the paper tray.
• Make sure the paper edges of the sheets are aligned to the front of the paper tray.
• Load translucent paper lengthways when possible.
• If the output copies are badly curled, turn the paper loaded in the cut paper trays upside down, or
remove the copies during the copy run.
Notes on using translucent paper
Smooth out any curls in the paper before loading it.
Load translucent paper lengthways when possible.
Hemmed paper
When using hemmed paper, wrinkles and other problems may occur on paper.
Use the following procedure when copying or printing onto hemmed paper:
• Use the bypass tray.
• Make sure the paper is straight, and align the paper guides of the bypass tray to the paper size.
• Load only one sheet at a time.
• Remove each paper from the output tray and place it on a flat surface.
• Due to the thickness of hemmed paper, image may be faint, blurred, or wrinkled, and paper jams
may occur. You may be able to prevent this by copying or printing on the rear surface of the paper
or feeding the bottom of the paper in first.
4. Appendix
86
4