Ricoh FT2012+, Руководство по эксплуатации

Страница: 78 / 88

DO’S AND DON’TS
Copier
General operation
❐
Open the copy tray under the following conditions:
✒
When you make 20 or more 8
1/2
" x 11", A4 copies
✒
When you make 10 or more 8
1/2
" x 14" copies.
✒
When you use curled paper.
❐
When using OHP sheets, set one sheet at a time into the bypass feed en-
trance and open the copy tray. Remove copies delivered to the copy tray
one by one.
❐
When you use translucent paper under low temperature and low humidity
conditions, it may be misfed. In this case, leave the paper for a while to
make the paper curl face down. Then, deliver the paper to the copy tray.
❐ If there is a large solid image on the original, the Add Toner
f
indicator
may be lit after copying although toner remains in the toner bottle. In this
case, turn the main switch off and then back on again.
❐ Under the following conditions, you might get light copies.
✒
When you make 150 or more copies continuously.
✒
When you make one solid full image copy.
✒
When you make copies when the Add Toner
f
indicator blinks.
❐
Copies may be curled after coming
out of the copier. If necessary, un-
curl the paper within 5 mm, 0.2" as
shown before inserting it in the by-
pass feed entrance to make a two-
sided copy.
❐
Keep the used imaging unit horizontal. If you tilt the imaging unit, toner may
be spilled out.
❐
If you move the imaging unit without the toner bottle being set properly,
toner may be spilled out.
❐
Do not expose the imaging unit (especially blue material) to the light.
❐ Do not store the imaging unit under high temperature and high humidity.
❐
When you replace the imaging unit, also change the ozone filter.
5 mm,
0.2"
M
A
INT
A
INING Y
O
UR COP
IE
R
DO’
S
A
ND DON’T
S
U
S
E
A
N
D
S
T
O
R
A
G
E
O
F
S
U
P
P
L
IE
S
DO’S AND DON’TS
65