Ricoh B804, Руководство по обслуживанию на месте

Страница: 53 / 82

Lower Tray (B804 Only)
The lower tray sensor actuator arm [A] rests on the top of the stack of stapled booklets as they are output
to the lower tray. A flap depressor [B] keeps the open ends of the booklets down.
The front lower tray full sensor (S34) [C] and rear lower tray full sensor (S33) [D] detect when the lower
tray is full of booklets.
• The front lower tray full sensor is mounted higher than the rear lower tray full sensor.
• The lower tray is stationary. When it becomes full, the stapling and folding job stops until booklets
are removed from the tray.
• If the lower tray is not installed (this is detected if the front and rear sensors remain OFF), the machine
will not operate in the booklet staple and fold mode. When booklet mode is selected, the tray full
message appears on the operation panel.
The combinations of the two actuators and two sensors as the actuator arm rises determines the number of
booklets that the lower tray can hold before the job stops.
The tray full detection depends on the size of the paper and the number of sheets in one stapled and folded
booklet.
In the table below, the conditions (
¶
Ready
·
Full 1,
¸
Full 2
¹
Full 3: See the illustration on the previous
page) refer to the states of the sensors described on the previous page.
Tray Movement Mechanism
51
2