Ricoh B804, Руководство по обслуживанию на месте

Страница: 23 / 82

Folding Horizontal Skew Adjustment (For B804 only)
• The fold unit is adjusted for optimum performance before the finisher is shipped from the factory. Do
this adjustment only if the edges of folded booklets are not even.
1. Switch the copier on and enter the SP mode.
2. Europe, Asia: Use SP6-134-001 (this is for A3 paper). North America: Use SP6-134-005 (this is for
DLT paper).
• If the original setting of SP6-134-001 or -005 is not "0", then you must do the vertical skew
adjustment (
*
"Fold Vertical Skew Adjustment") after you finish this horizontal skew procedure.
3. Use the 10-key pad to input "-2" (mm) for the SP value. (Press  to enter the minus sign.)
4. Press [#] then exit the SP mode.
5. Open the front door and pull the stapler unit [A] out of the finisher.
6. Open the guide plate [B].
7. Loosen the adjustment screw [C] and then tighten until it stops. (Do not over tighten.)
8. Remove the lock screw [D].
9. Raise the tip [E] of the adjustment screw very slightly and allow it to descend under its own weight.
Fold Unit
21
1