Ricoh B022, Руководство по обслуживанию, Страница: 858 / 878

SERVICE CALL CONDITIONS
B022/B027 7-12 SM
Code No. Symptom Possible Cause
Print image data transfer error 984 D
The image transfer from the controller
to the engine via the PCI bus does not
end within 15 s after starting.
•
Controller board defective
•
SBCU board defective
•
Connectors between SBCU and
controller loose or defective
Software write parameter setting error 986 D
An unstable area at the storage
destination in the settings table is set at
NULL for the parameter received by the
write module.
Download controller firmware again
Software performance error 990 D
The software attempted to perform an
unexpected operation.
•
Software defective
•
Internal parameter incorrect
•
Insufficient working memory
•
When this SC occurs, the file name,
address, and data will be stored in
NVRAM. This information can be
checked by using SP7-403. Note the
above data and the situation in which
this SC occurs. Then report the data
and conditions to your technical
control
center.
Software continuity error 991 C
The software attempted to perform an
unexpected operation. However, unlike
SC990, the object of the error is
continuity of the software.
•
No operation required. This SC code
does not appear on the panel, and is
only logged.
FCU board error 996 B
FCU board is connected but not ready.
•
FCU board defective and requires
replacement
•
Download FCU firmware
Application function selection error 997 B
The application selected by a key press
on operation panel does not start or
ends abnormally.
•
Download the firmware for the
application that failed
•
An option required by the application
(RAM, DIMM, board) is not installed
Application start error 998 D
After power on, the application does not
start within 60 s. (All applications
neither start nor end normally.)
•
Download controller firmware
•
Replace the controller board
•
An option required by the application
(RAM, DIMM, board) is not installed
Program download error 999 D
The download (program, print data,
language data) from the IC card does
not execute normally.
•
Board installed incorrectly
•
SBCU board defective
•
Controller board defective
•
IC card defective
•
NVRAM defective
•
Loss of power during downloading
•
Important Notes About SC999
•
Primarily intended for operating in the
download mode, logging is not performed
with SC999.
•
If the machine loses power while
downloading, or if for some other reason
the download does not end normally, this
could damage the controller board or the
PCB targeted for the download and
prevent subsequent downloading. If this
problem occurs, the damaged PCB must
be replaced.
Rev. 01/2003