5
Do not put too much glue, because when it melt and
during operation of the machine may overflow and cause
leaks. Let also not miss glue in the glue pot because this
can cause failures in the collage.
NOTE:
The brand and quality of the glue is fundamental.
The MAKSIWA recommends glues that work in the
range of 160°C to 190°C. On top of that, high
temperature and melt glues can damage the tape.
GLUE EXCHANGE:
If you change the color of your tape
or the color of the wood panel, you may change the glue
on your Edgebander. To change the glue follow these
steps, but first read the rest of this manual to be familiar
with all operations:
- Turn on the machine and set the temperature controller
to 70°C (158°F) (see this manual to program the
controller).
- At this temperature, the glue is not too hot (soft) or too
cold (hard). So you can remove the entire glue without
much difficulty.
- Use a trowel or piece of wood, avoiding scrape the
walls of collared, damaging the same.
- After removing all the glue, put the new glue.
- Set the temperature controller according to the
specification of the glue again.
GLUE
INDICATIONS:
With
this
machine
we
recommend the following glue brands:
Proadec - 160ºC a 180ºC
– Ivory-Color. Cod. 5707
Artecola - 180ºC a 180ºC - Ivory-Color. Cod. 1820
White. Cod. 1821
Kleiberit - 180ºC a 190ºC - Ivory-Color. Cod. 788.3/20
White. Cod. 788.3/10
Durante Duditerm
-
160ºC
a
180ºC - White. Cod. 715/15
2. TAPE (EDGEBAND)
The Edgebander CBC.E MAKSIWA is designed to work
with PVC tape, ABS, paper and wood that do not have
glue, only straight parts. Use tapes approximately 4mm
wider than the wood panel.
It is necessary to regulate the Edgebander according to
the thickness of the tape. That is, when changing the
thickness of the tape, it is necessary to adjust the
machine again. For this setting, follow these steps:
- Cut a piece of tape to be used.
- Loosen (without removing) the two screws shown in
the following figure, using a wrench 13:
- Insert the cut piece of tape behind the aluminum guide,
between the guide and the Allen screws, according to
the same figure above.
- Push the guide against the tape, without forcing much
so that the tape does not bend.
- Tighten the screws. The distance of the guide is
already adjusted according to the thickness of the tape.
Do not remove the piece of tape.
- With a piece of wood, make sure the guide is aligned
with the glue axis. To make this movement push the
wood against the aluminum guides entry sliding to
contact the glue axis. The glue axis must move slightly
(right of 0.5 to 1 mm) so that, when operating, passes
the glue without hitting brusquely in the glue axis. Just
touch lightly, passing the glue on the panel.
TAPE PLACEMENT:
To place your tape correctly,
follow these steps:
- Put the tape roll on the tape support previously
installed that already came with the machine.
- Insert the tape into the tape guide as shown in the
figure below, adjusting the knob
A
, so that the stops only
guide the tape at its height, without locking it. Make sure,
pulling and pushing the tape, you can move freely.
