10
SOLUTION GUIDE
PROBLEM
CAUSE
SOLUTION
Machine is not turn on
Plug
disconnected or connected
improperly.
Check the connection and the voltage of your
power supply.
Main switch off.
Turn on the Main switch.
ON switch off.
Turn on the ON switch (green).
Emergency switch activated.
Rotate clockwise to release.
Circuit breaker off.
Check the voltage of your Power supply
(110V) and turn on the breaker inside of
panel.
The glue is not heating
Temperature Controller
unregulated
.
Adjust the temperature settings.
Burned resistance.
Contact the Maksiwa Service to change the
resistance.
The tape is not gluing
The glue is not at the correct
temperature.
Check the glue temperature specification.
Missing glue at the glue axis.
Complete the glue pot with more glue.
The glue is inadequate to this
equipment.
Check the directions about glue brands in
this manual.
The thickness of the glue is incorrect.
Adjust the thickness of the glue (check this
manual).
The glue axis is out of bracket
(square).
Adjust the bracket of the glue axis (check this
manual).
The edge of the panel is out of square.
Check the square
of your panelyou’re your
panel saw.
