Rice Lake Challenger 3 MSI-3460, Техническое руководство

Страница: 15 / 46

Setup
© Rice Lake Weighing Systems ● All Rights Reserved 11
4.2.2 Total
Program the to

( Section 4.2 on page 10 ).
The function that will be performed when pressing , will need to be set in Section 4.7 on page 14 . If nothing has been set,
nothing will happen when is pressed.
The Total mode must be programmed from the Setup Menus before the USER key will function.
4.2.3 View Total
1. Program the to

( Section 4.2 on page 10 ).
2. Press to activate the total weight display followed by the number of samples.
3. With the Total weight displayed, press to clear.
4.2.4 Net / Gross
Switches the display between net and gross modes. Net weight is defined as gross weight minus a tare weight.
To switch between
Net mode and Gross mode:
1. Program the to

( Section 4.2 on page 10 ).
2. Press to toggle between net and gross values. This will only work if a tare value has been established.
The operator can switch back to gross from net without clearing the tare value. Only clearing or setting a new tare will change
the tare value held before switching into Gross mode.
OIML Legal for Trade units only: The
NET/GROSS
key is a temporary action only. The gross weight is displayed for two seconds
and then the display returns to the Net mode. The only way to return to permanent gross readings is to clear the tare
( Section 2.3.2 on page 5 ).
4.2.5 Peak Hold
Peak hold only updates the display when a higher weight reading is established.
The peak hold function uses a high speed mode of the A/D converter allowing it to capture transient weights at a far higher rate
than typical scales.
Peak hold is cleared and re-enabled with the
, that has been set to

-

. See Section 4.2 on page 10 ).
Peak hold is not available on NTEP or OIML Legal for Trade certified scales.
4.2.6 Units
Units can be changed in two ways.
• To use the , program it to

( Section 4.2 on page 10 ).
• Change the units with the setup menu ( Section 4.9 on page 16 ).
Unit switching is not available on OIML certified Legal for Trade scales.
4.2.7 Print
If the print option is installed, this menu choice will appear. See Section 6.1 on page 24 for print setup information.
USER
F
USER
F
USER
F
Note
USER
F
USER
F
ZERO
USER
F
USER
F
USER
F
USER
F
Note