MSI-3460 Challenger 3
14
Visit our website
To set the setpoint:
1. Press
and
simultaneously
.
displays.
2. Press
to scroll to the desired setpoint (
).
3. Press
. The current setpoint mode is displayed.
4. Press
to scroll to the setpoint mode desired.
5. Press
. The current setpoint weight type is displayed.
6. Press
to scroll to the desired weight type.
7. Press
. The current setpoint weight value is displayed.
8. Press
to scroll the numbers and
to enter each digit.
9. When the correct value is displayed, press
. The next setup menu item is displays.
To enter a decimal point, press
while the digit is blinking. To correct a digit, press
to step back.
10. Press
to exit setup and store the settings.
4.7 Total Mode
For the accumulation of multiple weighments, the Total function uses the displayed load, so gross and net readings can be
added into the same total.
There are four modes of totalizing; manual and three auto modes.
All modes require that the weight on the scale return below 0.5% (relative to full scale) of
GROSS ZERO
or
NET ZERO
before
the next weighment can be added. Applied weight must be ≥1% of full scale above
GROSS ZERO
or
NET ZERO
before it can
be totaled.
Manual Total
Manual Total (
) adds a current weight to a previously accumulated value manually. To add weight to the total it must be
greater than 1% of capacity and not yet totaled. This assures that a weight on the scale is only added to the total once.
1. Program the
to
(
).
2. With the weight to be added on the scale, press
. The acknowledge LED blinks to indicate the weight was
accepted and the
TOTAL
annunciator lights. Then the total weight is displayed for five seconds and the number of
samples is displayed for two seconds.
until all weight samples have been added.
Total Mode will not function while the scale is in motion, ensure MOTION annunciator is off. If the system fails to
achieve stable readings, increase the filter setting or increase the size of the scale division (d) in the Init Cal
procedure.
functions as View Total only until the 1% threshold is exceeded to allow the addition to the total value.
POWER
USER
F
USER
F
TARE
USER
F
TARE
USER
F
TARE
USER
F
TARE
TARE
Note
POWER
ZERO
ZERO
USER
F
USER
F
Note
USER
F
Содержание Challenger 3 MSI-3460
Страница 1: ...MSI 3460 Challenger 3 Technical Manual PN 152161 Rev F June 24 2021...
Страница 44: ...MSI 3460 Challenger 3 40 Visit our website www RiceLake com...
Страница 45: ......
