Page
16
/
27
IV. GETTING STARTED
Before any intervention on product, ensure that switch is off and plug is
disconnected from its power source.
4.1- Unpacking
Remove product from its packaging.
Check that tool and accessories are not damage.
4.2- Inserting and removing a nozzle
Only on PRDECA2000KIT/311019
- To install a nozzle
Insert accessory nozzle on main nozzle and ensure it is centered and properly fixed.
- To remove an accessory nozzle from the main nozzle: ensure the accessory nozzle is cooled down
and pull it out firmly
4.3- Switch On/Off
4.3.1- For PRDECA2000/311026
The switch (2) has 3 positions « 0 » (Off) and « I » , « II » (On).
To start the tool: position the switch on « I » or « II ».
To stop the tool: position tool on « 0 »
4.3.2- For PRDECA2000KIT/311019
The switch (2) has 4 positions « 0 » (Off) and « 1 », « 2 » et « 3 » (On).
To start the tool: position the switch on « 1 » or « 2 » or « 3 ».
To stop the tool: position tool on « 0 »
4.4- Heat and air flow adjustment
You can adjust the temperature and air flow through the settings of the switch
PRDECA2000/311026
PRDECA2000KIT/311019
Switch position
I
II
1
2
3
Temperature
450
C
600
C
50
C
50-450
C
50-600
C
Air flow
300 l/min
500 l/min
250 l/min
250 l/min
500 l/min
Note : on PRDECA2000KIT/311019, the temperature can be adjusted through the knob (7) located
on the rear side of the tool.
Position the main switch on « 2 » or « 3 », then adjust the temperature by rotating the knob
(settings from 1to 9) to regulate the temperature (see table above).
Warning: let tool and nozzle cool down before any intervention or before storing it.
4.5- Stationary use
The tool can be used in stationary mode:
Place tool on workbench or flat surface (strong and
stable surface) with the nozzle pointing up (see
Fig.2a and 2b).
Note : Secure the power cord to prevent it from
pulling the tool
Fig.2a
Fig.2b