not play with the product.
6. Do not damage the power cord
- Never move the product by dragging it by the power cable.
- Never pull the power cable to disconnect it.
- Do not step over the power cable.
- Keep the power cable away from heat, oil and sharp edges.
7. Safety at work
- Use proper protective equipment according to the work environment.
- Keep proper footing at all times and balance.
- If the motor overheats, stop it and leave it to cool down for a few minutes.
- Do not leave the power connected to the winch if the motor stops.
- Important: never exceed the maximum line pull ratings shown in the table.
- Do not pull loads greater than the maximal capacity of the winch.
- Do not attempt to pull stationary or fix loads.
- Do not apply any side force on the load
- Excessive inching (e.g. giving short pulses to the motor) shall be avoided.
- Never transport persons
8. Do not step over or under the product or steel cable
- During operation,
do not
step over or under the product or the steel cable.
9. Avoid starting the product unintentionally
-The winch clutch should be disengaged when the product is not in use, and fully engaged when
in use.
- Keep the remote control in a safe place. Be sure that the switch is in the “OFF” position when
not in use.
10. Check for damaged parts
- Before each use, check the product carefully. Any part that is damaged should be repaired or
replaced by an authorized service center.
- Do not use the product if the remote control does not operate properly.
11. Repair the tool
- When repairs are carried out, only identical replacement parts should be used to avoid
endangering the user.
- Repair the product by a qualified technician.
- Repairs should be carried out by qualified technicians, using only original spare parts; to avoid
any danger for the user.
12. Product maintenance
- Keep the product properly maintained and clean for a better and safer performance.
- Follow the instructions for lubricating and changing the accessories,
- Inspect power cords periodically and, if they are damaged, have them repaired or replaced by
an authorized service centre.
- Inspect all moving parts and mounting bolts and nuts prior to use
- Keep handles dry, clean and free from oil and grease.
13. Rewind the cable
To rewind the cable correctly, a slight load must be kept on the cable.
For this purpose, hold the cable in one hand (wearing protective gloves) and the remote control
in the other hand, starting as far back and as centrally as possible, walking up and keeping the
load on the cable as the winch is powered in.
Do not allow the cable to slip through your hand and do not approach the winch too closely.
Turn the winch off and repeat the operation until almost all of the cable has been rewound.
Disconnect the remote control and finish rewinding the cable by rotating the drum by hand
with the clutch disengaged.
If the winch is not accessible, rewind the cable with the winch turned on, keeping hands
clear.
