Page
33
/
38
V. OPERATION
5.1- Intended use
1. Cellar draining pump are submersible pumps intended for domestic use.
They should be used only for drying out flooded premises or for pumping water out of wells or
cellars or vessels.
2. This pump is designed to suck up clear water only with particles in suspension that are less than
[see specifications in Table 1] in diameter.
3. The pump is fully submersible: the immersion depth must not exceed 5m (refer to the technical
characteristics table).
4. The pump should not be used for sucking up liquids or materials that are corrosive, combustible
or explosive; fats, oils, waste water from toilet, food liquids …
5. The temperature of the liquid sucked up should not exceed 35°C.
6. Any other use, other than that described in the instructions, is likely to damage the pump and to
put the user in serious danger.
7. The tool is not intended for artisanal, commercial, professional and/or industrial use (for ex.: in
public parks…).
5.2- Operation
Ensure that battery is charged, otherwise proceed with charging.
Install the battery.
Set the switch to ON position “I”.
Once the pumping is finished, switch off the pump setting the switch to position “0”.
Warning!
Never operate the pump empty (without water).
The pump is not designed for continuous operation! (e.g. continuous water circulating operation).
The submersible pump must be immersed before switching on.
5.3- Advise for users
1. if discharge stops although the pump continues to function, switch it off immediately.
Unplug the pump from the mains and check to see what is causing the problem.
Never attempt to remove the turbine when the pump is still connected to the power supply.
2. The pump is fitted with a motor protected by a thermal safety.
In the event of overheating, the motor stops automatically. As soon as the temperature returns to
normal
push the red bottom (10) for reset.
Never place hands anywhere near the turbine during this phase. If remedial action is necessary,
always unplug the pump from the power supply first.
3. After having inadvertently pumped dirty water, water containing sand or other abrasive material,
the pump should be rinsed with clear water.
