Page
10
/
19
•
Refer to the instruction manual of Ribimex battery pack and charger for safety, quality and
operation instructions.
•
The light source cannot be replaced. If the light source is defective, the entire product must
be replaced.
•
To prevent unintentionally switching on, remove the battery pack from the product when it
is in transportation, storage or not in use.
•
Do not direct the light beam at persons or animals and do not stare into the light beam
yourself (even from a distance).
•
Do not allow children to use this worklight. Children can unintentionally blind themselves
or other persons.
•
This worklight is not permitted for illumination in road traffic.
•
Do not cover the lamp head while the product is operating. The lamp head warms up during
operation and can cause burns if this heat accumulates.
•
Always use the worklight on flat and stable ground.
IV. GETTING STARTED
4.1- Unpacking
•
Remove the product from packaging.
•
Check if the product and accessories (if any) are intact.
4.2- Content
•
1 worklight
•
1 instruction manual
4.3- Assembly
No assembly or adjustment is required by the user.
4.4- Switch On/Off
•
Install the battery pack into the worklight.
•
To switch on the light, press the power switch (3) once, the worklight work at LOW
brightness (1200 lm).
•
To switch to HIGH brightness (2400 lm), press the power switch (3) again.
•
To switch to flash mode, press the power switch (3) again.
•
To switch off the light, press the power switch (3) again.
4.5- Adjusting the angle of the light
•
Lossen the clamping knobs on both sides.
•
Adjust the angle of the light (adjustment range is
225°).
•
Tighten the clamping knobs after adjustment.